11-5. DOOR HANDLE REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
O-ring (Appendix G, Item 258.1)
Locknut (Appendix G, Item 172)
Locknut (Appendix G, Item 153.1)
Materials/Parts (Cont’d)
Lithium grease (Appendix C, Item 36)
Manual References
TM 9-2320-387-24P
Equipment Condition
Door latch cover removed (para. 11-6).
Maintenance Level
Unit
TM 9-2320-387-24-2
11-12
Change 1
1.
Remove locknut (1), washer(s) (3), lever (2), and washer(s) (3) from link rod (5.1) and door
handle (7). Discard locknut (1).
2.
Remove locknut (11), retainer washer (4), handle (7), O-ring (6), handle retainer (8), backing
plate (9), and gasket (10) from door (5). Discard locknut (11) and O-ring (6).
NOTE
Apply a light coat of white lithium grease to uncoated surfaces of
handle and O-ring prior to assembly.
1.
Install O-ring (6), handle retainer (8), backing plate (9), and gasket (10) on handle (7) and install
handle (7) on door (5) with retainer washer (4) and locknut (11).
NOTE
A total of six washers are required. Install washers under lever as
required to position link rod parallel to door.
2.
Install washer(s) (3), lever (2), washer(s) (3), and locknut (1) on door handle (7) and link rod (5.1).
b. Installation
a. Removal
FOLLOW-ON TASK:
Adjust door latch (para. 11-9).
1
2
3
4
3
11
6
7
10
9
8
5
5.1
