11-3. DOOR WINDOW REPLACEMENT (Cont’d)
TM 9-2320-387-24-2
11-8
Change 1
1.
Apply sealing compound to threads of five screws (1).
2.
Install spacer (4), seal (3), and clamp bar (2) on door (5) with five screws (1). Tighten screws (1) to
13-16 lb-in. (1.5-1.8 N•m).
CAUTION
Support window until retainer plates and negator springs are
installed.
3.
Position window (12) at bottom of window channels (6) in door (5) and slide window (12) to highest
position.
4.
Position hole in tongue end of negator spring assembly (17) over stud (23) on door (5).
5.
Install cotter pin (19) through hole in stud (23).
6.
Install negator spring assembly (17) on window frame (13) with two capscrews (9) and locknuts
(18). Tighten locknuts (18) to 10 lb-ft (14 N•m).
7.
Repeat steps 4 through 6 for remaining negator spring (17).
8.
Apply sealing compound to threads of four screws (11), and install locking rod (16) on window (12)
with two retainer plates (14), springs (15), and screws (11). Tighten screws (11) to 20-23 lb-in.
(2.2-2.6 N•m).
9.
Install two protective bumpers (26) on window channels (6) with four socket-head screws (25),
washers (7), and locknuts (8). Tighten locknuts (8) to 10 lb-ft (14 N•m).
10.
Install door cover (20) at bottom of grooves in door (5) with beveled corners down. Slide door cover (20)
up and secure door cover (20) to door (5) with five washers (24), lockwashers (22), and capscrews (21).
Tighten capscrews (21) to 20-23 lb-in. (2.2-2.6 N•m).
b. Installation
