11-4. DOOR LATCH MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Inspection
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Lockwasher (Appendix G, Item 202.1)
Locknut (Appendix G, Item 167)
Sealing compound (Appendix C, Item 72.1)
Manual References
TM 9-2320-387-24P
Equipment Condition
Door latch cover removed (para. 11-6).
Maintenance Level
Unit
TM 9-2320-387-24-2
11-10
Change 1
1.
Remove locknut (11) and bushing (10) from link rod (14) on door release handle (9). Discard
locknut (11).
2.
Remove link rod (14), washer (13), and spring (12) from door latch (4) and door release handle (9).
3.
Remove capscrew (1) and link rod boss (2) from door latch (4).
4.
Remove link rod boss (2) from door handle lever (8).
4.1. Loosen nut (16) and remove rod (17), lockwasher (18), and nut (16) from link rod boss (2). Discard
lockwasher (18).
5.
Remove four screws (3), door latch (4), two spacer plates (5), and spring (15) from door (7).
6.
Remove spring (15) from latch (4).
Refer to para. 10-56 for plusnuts (6) inspection and replacement.
1.
Install spring (15) on latch (4).
2.
Apply sealing compound to threads of four screws (3), and install two spacer plates (5), door
latch (4), and spring (15) on door (7) with screws (3).
3.
Apply sealing compound to threads of capscrew (1), and install link rod boss (2) on door latch (4)
with capscrew (1). Tighten capscrew (1) to 10 lb-ft (14 N•m).
3.1 Install nut (16) and lockwasher (18) on rod (17).
3.2 Install rod (17) on link rod boss (2) and tighten nut (16).
4.
Install rod (17) on door handle lever (8).
4.1. Install washer (13) and spring (12) on link rod (14).
5.
Install link rod (14) on door latch (4) and through door release handle (9).
6.
Attach link rod (14) to door release handle (9) with bushing (10) and locknut (11).
c. Installation
b. Inspection
a. Removal
