11-8. LOCKING ROD AND DOOR RELEASE HANDLE REPLACEMENT
This task covers:
a. Removal
b. Installation
NOTE
Replacement procedures for locking rod and door release handle
are basically the same. This procedure covers the left front door.
1.
Remove four retaining rings (7) from locking rod (6) and door release handle (11) and uncompress
spring (4).
2.
Remove four screws (10), lockwashers (9), washers (1), two retainer blocks (8), locking rod (6), door
release handle (11), retainer (5), and detent bracket (2) from door (3). Discard lockwashers (9).
3.
Remove spring (4) from locking rod (6).
1.
DELETED.
2.
Install spring (4) on locking rod (6), and install detent bracket (2), retainer (5), door release handle (11),
and locking rod (6) on door (3) with two retainer blocks (8), four washers (1), lockwashers (9), and
screws (10). Tighten screws (10) to 21 lb-in. (2 N•m).
3.
Compress spring (4) and install four retaining rings (7) on locking rod (6) and door release
handle (11).
b. Installation
a. Removal
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Four lockwashers (Appendix G, Item 200)
Manual References
TM 9-2320-387-24P
Equipment Condition
• Door link rod removed (para. 11-4).
• Door locking pawls and connecting rods removed
(para. 11-7).
Maintenance Level
Unit
TM 9-2320-387-24-2
11-16
Change 1
