10-53. FIRE EXTINGUISHER BRACKET MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Inspection
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Fire extinguisher removed (TM 9-2320-387-10).
Maintenance Level
Unit
TM 9-2320-387-24-2
10-88
Change 1
FOLLOW-ON TASK: Install fire extinguisher (TM 9-2320-387-10).
1.
Remove four capscrews (6) and retainer plate (4) from two supports (3).
2.
Remove four capscrews (1), washers (2), and fire extinguisher bracket (7) from retainer plate (4).
NOTE
For inspection and removal of struxnuts, refer to para. 10-56.
Inspect four struxnuts (5). Replace if damaged.
1.
Install fire extinguisher bracket (7) on retainer plate (4) with four washers (2) and capscrews (1).
Tighten capscrews (1) to 6 lb-ft (8 Nm).
2.
Install retainer plate (4) on two supports (3) with four capscrews (6). Tighten capscrews (6) to
68-82 lb-in. (8-9 Nm).
c. Installation
b. Inspection
a. Removal
7
1
6
3
5
4
3
2
