TM 9-2320-387-24-l
6-9.
GEARED HUB REPLACEMENT (Cont’d)
8.
9.
10.
11.
WARNING
Geared hub must be supported during removal. Failure to support geared
hub may cause injury to personnel or damage to equipment.
NOTE
Note direction of inner and outer capscrews for installation.
Remove four locknuts (181, washers (141, capscrews (151, and washers (14) from lower ball joint (16) and
lower control arm (17). Discard locknuts (18).
Remove four locknuts (31, washers (21, capscrews (11, and washers (2) from upper ball joint (4) and
upper control arm (5). Discard locknuts (3).
Remove cotter pin (23), slotted nut (241, and upper ball joint (4) from upper control
geared hub (12). Discard cotter pin (23).
Lower support and remove geared hub (12).
(
arm (5) and
6-23
