TM 9-2320-387-24-l
4-79. HOOD JUMPER WIRING HARNESS REPLACEMENT (Cont’d)
pI7izEq
1.
2.
3.
4.
Position left side hood jumper wiring harness (14) in approximate mounting position.
Install rubber grommet (15) on hood (7).
5.
6.
Connect ground lead 92C (2) to blackout drive light (1).
Place coned mounting washer (91, ground lead 19B (31, and blackout drive light (1) through hole in
swivel bracket (8).
Install blackout drive light (1) on hood (7) with special washer (6), lockwasher (51, and nut (4).
Apply antiseize compound to left composite light ground lead 92C (12) and install on buss bar (13)
with lockwasher (10) and capscrew (11).
7.
Connect harness leads 20E (19),461B (181, and 491B (16) to left composite light terminals (17).
CAUTION
Use care when installing harness. Failure to do so may cause
damage to harness.
4-143
