TM 9-2320-387-24- 1
I
3-57. EXHAUST MANIFOLDS REPLACEMENT
This task covers:
a. Removal
INITIAL SETUP:
b. Installation
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
hlanual References
ThI 9-2320-387-24P
Equipment Condition (Cont’d)
l Air horn removed (para. 3-14) (right side only).
l Right exhaust manifold heat shield removed
(para. 3-56) (right side only).
l Rear heat shield removed (para. 3-52) (left side only).
Equipment Condition
General Safety Instructions
l Oil dipstick tube removed (para. 3-2)
(left side only).
l 200-ampere alternator removed
!para. 4-5) (left side only).
Do not touch hot exhaust system components
with bare hands.
hlaintenance
Level
Unit
WARNING
Do not touch hot exhaust system components with bare hands.
Severe injury may result.
NOTE
The replacement procedure for right and left exhaust manifolds is
basically the same. This procedure covers the right exhaust
manifold.
a. Removal
1.
Loosen and slide clamp (4) onto exhaust pipe (5).
2.
Remove four (eight if left side) capscrews (1) and exhaust manifold (2) from cylinder head (3).
-1
1.
Install exhaust manifold (2) on cylinder head (3) with four (eight if left side) capscrews (1). Tighten
capscrews (1) to 25-33 lb-ft (34-45 N.m).
2.
Install e.xhaust pipe (5) on exhaust manifold (2) and tighten clamp (4).
3-104
