TM 9-2320-387-24-l
9-8. REAR BUMPER INNER MOUNTING BRACKET REPLACEMENT
This task covers:
a. Removal
h. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Manual References
TM 9-2320-387-24P
Maintenance Level
Unit
Six locknuts (Appendix G, Item 121)
1.
Remove two locknuts (31, washers (41, capscrews (91, and washers (4) from bracket (7) and
rear bumper (1). Discard locknuts (3).
NOTE
Spacer is present on Ml114 vehicle only
2.
Remove four locknuts (101, washers (61, capscrews W, washers (61, bracket (7), and spacer (81
from frame rail (2). Discard locknuts (101.
j[
NOTE
l Spacer is present on Ml114 vehicle only.
l Ensure spacer on outer side of frame rail is in position before
installing spacer and bracket.
1.
Install spacer (8) and bracket (7) on frame rail (2) with four washers (6), capscrews (51, washers (61,
and locknuts (101. Tighten capscrews (5) to 90 lb-ft (122 N-m).
2.
Install bracket (7) on rear bumper (11 with two washers (41, capscrews (91, washers (41, and
locknuts (31. Tighten locknuts (31 to 90 lb-R (122 N-m).
9-10
