TM 9-2320-387-24-1
7-14. REAR DUAL SERVICE/PARKING BRAKE PAD MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Cleaning and Inspection
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Wheels chocked and parking brake released
(TM 9-2320-387-10).
General Safety Instructions
Ensure brake pads are installed with linings
facing rotor.
Maintenance Level
Unit
7-38
Change 1
a. Removal
1.
Remove cotter pin (4), washer (5), and clevis pin (7) from parking brake clevis (6) and lever (3).
Discard cotter pin (4).
2.
Remove clip (2) and disconnect parking brake cable (8) from caliper cable bracket (1). Discard
clip (2).
CAUTION
Caliper must be supported during removal to prevent damage to
brake line.
3.
Using crowfoot, remove two capscrews (12), washers (13), clamp (13.1), and pull yoke (14) and caliper
(15) away from rotor (10).
NOTE
Note positioning of brake pad surfaces for installation.
4.
Remove two brake pads (9) from adapter (11) and rotor (10).
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Special Tools
Crowfoot, 14-mm (Appendix B, Item 141)
Materials/Parts
Clip (Appendix G, Item 22)
Cotter pin (Appendix G, Item 33)
Sealing compound (Appendix C, Item 63)
Grease (Appendix C, Item 34)
