TM9-2320-387-24-l
7-l 1. BRAKE PROTECTION GUARDS REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
MaterialsZarts
Six locknuts (Appendix G, Item 156)
Manual References
TM 9-2320-387-24P
Equipment Condition
Vehicle raised and supported (para. 8-2).
Maintenance Level
Unit
NOTE
The replacement procedure for brake protection guards is
basically the same for front and rear brakes. This procedure
covers the front brake protection guards.
a. Removal
1.
Remove four locknuts (41, washers (5), capscrews (71, washers (51, and two right-side brake protection
guards (8) from brackets (6) on crossmembers (9). Discard
locknuts (4).
2.
Remove two locknuts (31, washers (21,
capscrews (101, washers (21, and left-side brake protection
guard (11) from brackets (1) on crossmembers (9). Discard locknuts (3).
(J
1.
Install left-side brake protection guard (11) on two brackets (1) on crossmembers (9) with two
washers (2), capscrews (101, washers (21, and locknuts (3).
2.
Install two right-side brake protection guards (8) on two brackets (6) on crossmembers (9) with four
washers (5), capscrews (7), washers (5), and locknuts (4).
7-34
