TM 9-2320-387-24-1
7-15. REAR DUAL SERVICE/PARKING BRAKE CALIPER MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Cleaning and Inspection
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Wheels chocked and parking brake released
(TM 9-2320-387-10).
Maintenance Level
Unit
7-42
Change 1
a. Removal
CAUTION
Cover or plug all open lines and connections immediately after
disconnection to prevent contamination. Remove all plugs prior to
connection.
1.
Remove cotter pin (4), washer (5), and clevis pin (7) from parking brake clevis (6) and lever (3).
Discard cotter pin (4).
2.
Remove clip (2) and disconnect parking brake cable (8) from caliper cable bracket (1). Discard
clip (2).
NOTE
Have drainage container ready to catch brake fluid.
3.
Disconnect brake line (17) from coupling (16).
4.
Remove coupling (16) and copper washer (15) from caliper (14). Discard copper washer (15).
5.
Using crawfoot, remove two capscrews (10), washers (11), clamp (11.1), and pull yoke (12) and
caliper (14) away from adapter (9).
6.
Slide yoke (12) and locating pins (13) out from caliper (14).
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Special Tools
Crowfoot, 14-mm (Appendix B, Item 141)
Hex-head driver, 7-mm
(Appendix B, Item 151)
Materials/Parts
Cotter pin (Appendix G, Item 33)
Copper washer (Appendix G, Item 24)
Clip (Appendix G, Item 22)
Sealing compound (Appendix C, Item 63)
