TM 9-2320-362-14&P
4-10. POWER INTERFACE BOX TERMINAL REPLACEMENT
This task covers:
a. Terminal 11E1 Removal
g. Terminal 11E4 Removal
b. Terminal llE1 Installation
h. Terminal 11E4 Installation
c. Terminal 11E2 Removal
i. Terminal 11E5 Removal
d. Terminal 11E2 Installation
j.
Terminal 11E5 Installation
e. Terminal 11E3 Removal
f. Terminal 11E3 Installation
INITIAL SETUP:
Tools
Materials/Parts
General mechanic’s tool kit:
Two self-locking nuts
automotive (Item 1, Section III,
P/N MS21044C3
Appendix B)
Equipment Condition
Materials/Parts
Power interface box removed
One gasket P/N C5136331
(para. 3-30a)
Sealant, exterior (Appendix C,
Item 6)
a. Terminal llE1 Removal
1.
Remove sixteen screws (4), cover (3) , and gasket (2) from power
interface box (1).
Discard gasket (2).
2.
Remove nut (10), lockwasher (9), and washer (8) that secure bus
bar (6) to terminal 11E1 (5).
3.
Remove nut (7) from inside terminal 11E1 (5).
Remove terminal
11E1 (5).
b. Terminal 11E1 Installation
1.
Apply sealant to area of terminal that contacts power interface
box (1).
2.
Install terminal 11E1 (5) into power interface box (1) and secure
with nut (7).
3.
Secure bus bar (6) to terminal 11E1 (5) with washer (8),
lockwasher (9), and nut (10).
4.
Install gasket (2) and cover (3) on power interface box (1) and
secure with sixteen screws (4).
4-12
