TM 9-2320-362-14&P
4-9. INDICATOR LIGHT AND WIRE ASSEMBLIES REPAIR
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Materials/Parts (Cont)
General mechanics tool kit:
One indicator light
automotive (Item 1, Section III,
P/N 367-8430-09-503
Appendix B)
One wire assembly
Soldering gun (Item 3,
P/N C5136333
Section III, Appendix B)
One wire assembly
Multimeter, AN/URM-105C (Item 3,
P/N C5136332
Section III, Appendix B)
Solder, tin alloy (Appendix C,
Materials/Parts
Item 8)
Four lockwashers
Equipment Condition
P/N MS35338-138
Power interface box removed
One gasket P/N C5136331
(para. 3-30a)
1.
2.
3.
4.
5.
6.
7.
8,
9.
10.
11.
NOTE
Tag wires for installation.
Remove sixteen screws (9), cover (8) , and gasket (7) from power
interface box (4).
Discard gasket (7).
Remove screw (11), wire assembly lead (12), washers (22), and
nut (23) that secure bus bar (21) to bus bar (25).
Remove nut (19), lockwasher (18), and washer (17) that secure bus
bar (24) to terminal 11E4 (27).
Remove four screws (32), lockwashers (31), and washers (30) from
guard (28).
Discard lockwashers (31).
Remove guard (28) and boot (29) from power interface box (4).
Remove circuit breaker (20) from power interface box (4).
Remove nut (16), lockwasher (15), and washer (14) that secure
wire assembly lead (13) and bus bar (10) to terminal 11E5 (26).
Detach wire assembly lead (13).
Remove indicator light lens (1) and incandescent lamp (2).
Remove nut (6) and internal tooth washer (5) on indicator
light (3).
Remove indicator light (3) from power interface
box (4).
Perform continuity test on indicator light (3) and wire assembly
leads (12) and (13).
Desolder wire assembly leads (13) and/or (12) from back of
indicator light (3).
Discard wire assembly leads (13), (12), and/or
indicator light (3).
4-8
