TM 9-2320-362-14&P
3-31. POWER INTERFACE BOX REPAIR (Cont’d)
e. Power Terminals Cover Removal
1.
File small flat on rivet heads (4) on power terminals cover side of
hinge (3).
2.
Center punch flats while supporting rivet backsides (4).
WARNING
When drilling, be sure to wear goggles for eye
protection or injury to personnel may occur.
3.
Using 3/16-inch drill bit, drill through rivet heads (4) on power
terminals cover side of hinge (3),
4.
Unlatch clamping catch (1) from strike (5).
5.
Remove two screws (7) and lockwashers (6) from strike (5). Remove
strike (5) and cover (2).
Discard lockwashers (6).
f. Power Terminals Cover Installation
1.
Place cover (2) in position.
2.
Place hinge (3) in position.
3.
Rivet hinge (3) to cover (2).
4.
Install strike (5) to cover (2) and
lockwashers (6).
5.
Close cover (2) and fasten clamping
secure with two screws
catch (1) to strike (5)
(7) and
3 - 7 4
