TM 9-2320-362-14&P
I
3-31. POWER INTERFACE BOX REPAIR
I
a.
b.
c.
d.
e.
f.
Hinge Removal
i. Guard and Boot Removal
Hinge Installation
j. Guard and Boot Installation
Strike and Clamping Catch
k. Cable W67 Removal
Removal
1. Cable W67 Installation
Strike and Clamping Catch
m. Cable W69 Removal
Installation
n. Cable W69 Installation
Power Terminals Cover Removal
Power Terminals Cover
Installation
Terminal Cover Removal
Terminal Cover Installation
g.
h.
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Item 1, Section III,
Appendix B)
Drill bit, 3/16-inch (Item 2,
Section III, Appendix B)
Drill, electric (Item 2,
Section III, Appendix B)
Riveter, blind hand (Item 2,
Section III, Appendix B)
Materials/Parts
Four lockwashers
P/N MS35338-138
Nine dome head rivets
P/N 1601-0619
One lockwasher P/N 85031
Materials/Parts (Cont’d)
Two lockwashers
P/N MS35338-136
Two self-locking
P/N MS21044C06
Two self-locking
P/N MS21044C3
nuts
nuts
Equipment Condition
Power interface box removed
(para 3-30a)
General Safety Instructions
When drilling, be sure to wear
goggles for eye protection.
1.
File small flat on rivet heads (l).
2.
Center punch flats while supporting rivet backsides.
WARNING
When drilling, be sure to wear goggles for eye
protection or injury to personnel may occur.
3.
Using 3/16-inch drill bit, drill through all rivet heads (1).
4.
Pry off rivet heads (1) and tap out rivet shanks.
Remove hinge (3).
b. Hinge Installation
1.
Place hinge (3) in position.
2.
Rivet hinge to power interface box (2).
3 - 70
