c. Adjustment
a. Removal
b. Installation
TM 9-2320-280-20-3
12-48. ARCTIC HEATER EXHAUST DIVERTER CABLE ASSEMBLY MAINTENANCE
This task covers
a.Removal
c. Adjustment
b. Installation
INITIAL SETUP:
Tools
Manual References
General mechanic’s tool kit:
TM 9-2320-280-10
automotive (Appendix B, Item 1)
TM 9-2320-280-24P
Materials/Parts
Cotter pin (Appendix G, Item 27)
• Hood raised and secured (TM 9-2320-280-10).
• Engine right splash shield removed (para. 10-20).
• Arctic heater assembly removed (para. 12-41).
1. Loosen nut (2) and remove knob (1) and nut (2) from cable assembly core (6).
2. Remove nut (3), washer (4), and cable assembly (9) from plenum bracket (5).
3. Remove grommet (8) from cowl opening (7) and pull cable assembly (9) through cowl opening (7).
4. Remove capscrew (15), washer (16), and cable bracket (17) from diverter box (18).
5. Remove cotter pin (11) and washer (10) from cable pin (13) and exhaust diverter lever (12). Disconnect
cable pin (13) from exhaust diverter lever (12) and remove cable assembly (9), Discard cotter pin (11).
1. Install cable pin (13) on exhaust diverter lever (12) with washer (10) and cotter pin (11).
2. Install cable bracket (17) on diverter box (18) with washer (16) and capscrew (15).
3. Push cable assembly (9) through cowl opening (7) and install grommet (8) on cowl opening (7).
4. Connect cable assembly (9) to plenum bracket (5) with washer (4) and nut (3).
5. Install nut (2) and knob (1) on cable assembly core (6) and tighten nut (2) on knob (1).
1. Loosen screw (14) on cable assembly core (6) to cable pin (13).
2. Ensure knob (1) is pushed all the way in (exhaust position).
3. Ensure exhaust diverter lever (12) on diverter box (18) is in the full vertical position
(exhaust position).
4. Tighten screw (14) on cable assembly core (6) on cable pin (13).
12-70
