12-47. ARCTIC HEATER DIVERTER BOX COVER REPLACEMENT
This task covers:
a. Removal
b. Installation
a. Removal
1.
Remove five rivets (4) and washers (3) from cover (1) and diverter box (2).
2.
Peel back cover (1) and remove from diverter box (2).
3.
Clean remaining adhesive, dirt, and oil from diverter box (2).
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Adhesive (Appendix C, Item 3)
Five rivets (Appendix G, Item 193)
Manual References
TM 9-2320-280-24P
b. Installation
1.
Apply adhesive to surface of diverter box (2) and rough surface of cover (1).
2.
Install cover (1) on diverter box (2), pressing firmly in place.
3.
Secure cover (1) to diverter box (2) with five washers (3) and rivets (4).
4.
Ensure cover (1) is attached at all bends and corners of diverter box (2).
5.
Remove backing from two data plates (6) and install data plates (6) on cover (1).
6.
Remove backing from warning plate (5) and install warning plate (5) on cover (1).
TM 9-2320-280-20-3
Change 1
12-69
NOTE
For rivet replacement instructions, refer to para. 10-66.
