TM 9-2320-280-20-3
10-23. WINDSHIELD ASSEMBLY MAINTENANCE
I
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP:
Applicable Models
M998, M998A1, M1035, M1035A1, M1035A2,
M1037, M1038, M1038A1, M1042
ToolS
General mechanics tool kit:
automotive (Appendix B, Item 1)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
l Soft top enclosure removed, if install.
(TM 9-2320-280-10).
s Windshield wiper blade and arm removed
(para. 10-70).
. Windshield wiper linkage removed (para. 10-73).
l Windshield wiper arm pivots removed
(para. 10-74).
General Safety Instructions
Windshield must be supported during removal and
installation.
Windshield must be supported during removal and installation.
Failure to support windshield may cause injury to personnel or
damage to equipment.
a. Removal
1. Remove five hitch pins (5) from five hinge pins (6).
2. Remove five hinge pins (6) from upper hinge halves (2) and lower hinge halves (4).
3. Remove grommet (11) from A pillar (12) and remove jumper harness (10).
4. Remove windshield assembly (1) from A pillar (12).
5. Remove two seals (3) from windshield assembly (1).
6. Clean remains of seal (3) from windshield assembly (1).
b. Disassembly
1. Remove thirteen screws (9), former (8), and seal (7) from windshield assembly (1).
2. Clean remains of seal (7) from windshield assembly (1).
1. Peel paper backing from seal (7) and install seal (7) on windshield assembly (1).
2. Install former (8) on seal (7) and windshield assembly (1) with thirteen screws (9).
d. Installation
1. Peel paper backing from two seals (3) and install seals (3) on windshield assembly (1).
2. Install windshield assembly (1) on A pillar (12).
3. Install jumper harness (10) on windshield center piller (13) and install grommet (11) on A pillar (12).
4. Install upper hinge halves (2) on lower hinge halves (4) with five hinge pins (6).
5. Install five hitch pins (5) in hinge pins (6).
10-42