TM 9-2320-280-20-3
11-120. SHELTER REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
M1037, M1042, M1097, M1097A1, M1097A2
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Eight capscrews (Appendix G, Item 11)
Eight lockwashers (Appendix G, Item 128)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Tailgate lowered (TM 9-2320-280-10).
General Sadety Instructions
Direct all personnel to stand clear during hoisting
operations.
WARNING
Direct all personnel to stand clear during hoisting operations. A
heavy, swinging load can be extremely dangerous.
1. Position chain hoist (2) over top of shelter (3).
2. Connect lifting chains (1) to chain hoist (2) and four comers of shelter (3).
NOTE
It maybe necessary to detach cab rear panel straps and
turnbuttons and roll cab rear panel upward to gain access to front
mounting brackets.
3. Remove eight capscrews (12), lockwashers (11), washers (10), and four reinforcements (9) from four
mounting brackets (6) and support assembly (4), and remove shims (7), if present. Discard
capscrews (12) and lockwashers (11).
4. Remove shelter (3) from support assembly (4) and vehicle body with chain hoist (2).
5. Remove mounting brackets (para. 11-116).
WARNING
Direct all personnel to stand clear during hoisting operations. A
heavy, swinging load can be extremely dangerous.
1. Install mounting brackets (pare. 11-116).
2. Install shelter (3) over support assembly (4) and gradually lower shelter (3) into Position on support
assembly (4).
NOTE
Shelter should be tightly fitted to front of support assembly and centered
from side to side. Shims should only be added to rear shelter mounts.
3. Position shelter (3) on support assembly (4) and front mounting points (5) and install front of shelter (3)
on front of support assembly (4) with two reinforcements (9), four washers (10), lockwashers (11), and
capscrews (12). Tighten capscrews (12) to 90 lb-ft (122 N.m) and capscrews (8) to 60 lb-ft (81 Nom).
11-168
