10-76. WINDSHIELD WASHER HOSES REPLACEMENT
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Hood raised and secured (TM 9-2320-280-10).
This task covers:
a. Removal
b.
Installation
a. Removal
1.
Remove nut (18), washer (4), capscrew (5), and washer (4) from clamp (3), and remove washer
hose (1) from body hood rail (13).
2.
Remove two nuts (11), washers (10), capscrews (16), and washers (10) from clamps (9), and remove
washer hose (12) from top of body hood rail (13).
3.
Loosen clamp (14) and disconnect washer hose (12) from pump (15) and tee (6), and remove through
clamp (17).
4.
Disconnect washer hose (7) from tee (6) and nozzle (8) and remove through clamp (17).
5.
Disconnect washer hose (1) from tee (6) and nozzle (2) and remove through clamp (17).
b. Installation
1.
Install washer hose (1) through clamp (17) and connect to nozzle (2) and tee (6).
2.
Install washer hose (7) through clamp (17) and connect to nozzle (8) and tee (6).
3.
Install washer hose (12) through clamp (17) and connect to tee (6) and pump (15) and tighten
clamp (14).
NOTE
When mounting the clamps, ensure they are positioned below the
hood rest, so when the hood is closed it does not interfere with the
clamps or hose.
4.
Install washer hose (1) on body hood rail (13) and secure with clamp (3), washer (4), capscrew (5),
washer (4), and nut (18).
5.
Install washer hose (12) under body hood rail (13) and secure with two clamps (9), washers (10),
capscrews (16), washers (10), and nuts (11).
TM 9-2320-280-20-3
10-126
Change 1