TM 9-2320-280-20-2
6-9. HALFSHAFT MAINTENANCE (Cont’d)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
NOTE
Perform steps 1 through 3 for all models except the M1097 and
“A1” and “A2” series vehicles.
Install spacer (9) and retainer ring (10) on shaft (7).
Align splines on shaft (7) to outer joint (8) and push outer joint (8) onto shaft (7) until it snaps
in place.
Install slinger (11) on outer joint (8).
Pack outer joint (8) with lithium grease.
Install outer boot (6) on shaft (7). Ensure boot (6) seats in groove of shaft (7).
Secure outer boot (6) on shaft (7) with clamp (4).
Install outer boot (6) on joint (8). Ensure boot (6) seats in groove of joint (8).
Secure outer boot (6) on joint (8) with clamp (5).
Clamp shaft (7) in soft-jawed vise.
Position clamps (3) and (2) on shaft (7).
Install inner boot (1) on shaft (7). Push boot (1) past groove on shaft (7).
Position ball race (13) on shaft (7).
6-21
