6-9. HALFSHAFT MAINTENANCE (Cont’d)
b. Disassembly
1.
Loosen two clamps (7) and (8) securing inner boot (6) to inner joint (1) and shaft (5).
2.
Clamp shaft (5) in soft-jawed vise.
3.
Remove inner boot (6) from inner joint (1) and slide up on shaft (5).
4.
Remove retainer clip (2) from inner joint (1).
5.
Remove inner joint (1), retainer clip (2), and six ball bearings (3) from bearing assembly (4).
NOTE
Perform steps 5.1 through 5.3 for M1123 and “A2” series vehicles.
5.1. Remove inner boot (6) from insert (9) and slide up on shaft (5).
5.2. Remove inner joint (1) and insert (9) from spider assembly (10) and shaft (5).
5.3. Remove insert (9) from inner joint (1). Discard insert (9).
TM 9-2320-280-20-2
6-18
Change 2
M1123 AND
“A2” SERIES
