6-9. HALFSHAFT MAINTENANCE (Cont’d)
TM 9-2320-280-20-2
6-22.2
Change 2
e. Installation
1.
Install halfshaft (9) into geared hub (4).
2.
Apply sealing compound to halfshaft retaining capscrew (6) and install halfshaft (9) to geared
hub (4) with lockwasher (5) and halfshaft retaining capscrew (6). Tighten halfshaft retaining
capscrew (6) to 37 lb-ft (50 N•m).
3.
Install washer (7) and access plug (8) into geared hub (4). Tighten access plug (8) to 8-13 lb-ft
(11-18 N•m).
NOTE
Ensure all six capscrew holes in the rotor align with holes
in output flange.
4.
Apply sealing compound to six capscrews (3). Install halfshaft (9) to rotor (1) and output flange (10),
with six lockwashers (2) and capscrews (3). Tighten capscrews (3) to 48 lb-ft (65 N•m).
NOTE
Perform steps 5 through 7 for rear halfshafts only.
5.
Install parking brake cable (11) to caliper cable bracket (12) with clip (13).
CAUTION
• Ensure lever is in contact with caliper cable bracket stop.
Damage to equipment and poor performance will result if
not aligned properly.
• Ensure that the clevis and clevis pin are aligned in the lever.
Do not move the lever to accommodate misadjusted clevis.
Damage to equipment and poor performance may result.
6.
Install parking brake clevis (17) to lever (14) with clevis pin (18), washer (16), and cotter pin (15). Check
position of lever (13) and ensure it is in contact with caliper cable bracket stop (13.1).
7.
If lever (14) is not in contact with caliper cable bracket stop (13.1), adjust rear dual service parking
brake (para. 7-26).
