TM 9-2320-280-20-2
4-104. RESUSCITATOR/ASPIRATOR CABLE REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Manual References
M996, M996A1, M997, M997A1, M997A2
TM 9-2320-280-24P
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
NOTE
Replacement of resuscitator/aspirator cable is basically the same
for M996, M996A1, M997, M997A1, and M997A2 vehicles. This
procedure covers M997, M997A1, and M997A2 vehicles.
For instructions on replacement of rivets, refer to para. 10-66.
a. Removal
1. Remove two screws (3), clamps (7), and cable (1) from body (2) and floor (6).
2. Remove nine rivets (4) from cable duct (5) and floor (6) and slide duct (5) left to remove.
3. Remove two screws (9), clamps (10), cable (1), and power harness clamp (8) from body (2).
4. Remove grommet (11) from floor (6) and remove cable (1) through hole in floor (6).
1. Install grommet (11) in floor (6).
2. Route cable (1) through grommet (11) in floor (6) and position in approximate mounting location.
3. Connect cable (1) to resuscitator and power source. (Leave slack at each end of cable before clamping
to connect resuscitation equipment if not installed.)
4. Install two clamps (7) and cable (1) on body (2) and floor (6) with two screws (3).
5. Install cable duct (5) over cable (1) and slide to right under heat duct to mounting position.
6. Install cable duct (5) on floor (6) with nine rivets (4).
7. Install two clamps (10), cable (1), and power harness clamp (8) on body (2) with two screws (9).
4-234
