4-52. FRONT COMPOSITE LIGHT ASSEMBLY REPLACEMENTThis task covers:a. Removalb. Installationa. Removal1.Remove four screws (1), washers (2), and close-off cover (3) from hood (4).2.Disconnect leads 20 (5), 461 (12), and 491 (11) from hood wiring harness (6).3.Remove two capscrews (9), lockwashers (8), ground 92 (7), buss bar (10), and composite light (13)from hood (4). Discard lockwashers (8).INITIAL SETUP:ToolsGeneral mechanic’s tool kit:automotive (Appendix B, Item 1)Materials/PartsTwo lockwashers (Appendix G, Item 110)Adhesive sealant (Appendix C, Item 10)Manual ReferencesTM 9-2320-280-10TM 9-2320-280-24PEquipment Condition_________________Battery ground cable disconnected (para. 4-73).NOTETo prevent water from accumulating between the composite lightaccess cover and the hood, general purpose RTV adhesive sealantshould be applied to the inside of the cover. Clean and reapplyRTV when removing and reinstalling the cover.1.Install composite light (13), buss bar (10), and ground 92 (7) on hood (4) with two lockwashers (8)and capscrews (9).2.Connect lead 20 (5), 461 (12), and 491 (11) to hood wiring harness (6).3.Install close-off cover (3) to hood (4) with four washers (2) and screws (1).TM 9-2320-280-20-24-86Change 2b. InstallationNOTE• The procedure to remove and install right and left composite lightassemblies is basically the same except left side has four screwssecuring close-off cover and right side has three screws. Thisprocedure covers the left composite light.• Prior to removal, tag leads for installation.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business