TM 9-2320-280-20-2
4-50. BlACKOUT DRIVE LIGHT ASSEMBLY REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Lockwasher (Appendix G, Item 108)
Battery ground cable disconnected (para. 4-73).
Four nut and lockwasher assemblies
Hood raised and secured (TM 9-2320-280-10).
(Appendix G, Item 144)
Antiseize compound (Appendix C, Item 13)
a. Removal
1. Remove nut (5), lockwasher (6), and special washer (7) from blackout drive light (1) and hood (9).
Discard lockwasher (6).
2. Disconnect lead 198 (4) from blackout drive light (1).
3. Remove blackout drive light (1) and coned mounting washer (2) from swivel bracket (11).
4. Disconnect lead 92C (3) from blackout drive light (1).
NOTE
Some vehicles may have screws in place of studs securing bracket
and plate to hood.
5. Remove four nut and lockwasher assemblies (8), swivel bracket (11), and plate (10) from hood (9).
Discard nut and lockwasher assemblies (8).
b. Installation
NOTE
Some vehicles may have screws in place of studs securing bracket
and plate to hood.
1. Install swivel bracket (11) to outside of hood (9), and plate (10) to inside of hood (9) with four nut and
lockwasher assemblies (8). Tighten nut and lockwasher assemblies (8) to 16-30 lb-in. (1-3 Nom).
2. Connect lead 92C (3) to blackout drive light (1).
3. Place blackout drive light (1) and coned mounting washer (2) through hole in swivel bracket (11).
4. Connect lead 198 (4) to blackout drive light (1).
5. Install blackout drive light (1) on hood (9) with special washer (7), lockwasher (6), and nut (5).
4-82
