TM 9-2320-280-20-2
4-36
Change 2
4-17. WAIT-TO-START LAMP REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Battery ground cable disconnected (para. 4-73).
Instrument cluster removed (para. 4-11).
a. Removal
1.
Loosen nut (14) and lower steering column (7).
2.
Remove cannon plug (16) from main light switch (15).
3.
Remove two capscrews (17), washers (18), nuts (20), and washers (18) from instrument panel (6) and
body (19).
4.
Remove nut (22) and screw (23) from hand throttle bracket (21) and instrument panel (6).
5.
Remove nut (13), washer (11), capscrew (10), and washer (11) from instrument panel (6), hand
throttle bracket (21), and steering column bracket (12).
6.
Remove screw (8) from instrument panel (6) and cowl (9).
7.
Pull instrument panel (6) away from body (19).
8.
Remove two screws (5) from wait-to-start lamp (4) and instrument panel (6).
9.
Disconnect lead 571 (2) and 27 (3) from wiring harness (1).
10.
Remove wait-to-start lamp (4).
NOTE
Prior to removal, tag leads and note position for installation.
b. Installation
1.
Connect lead 571 (2) and 27 (3) to wiring harness (1).
2.
Install wait-to-start lamp (4) on instrument panel (6) with two screws (5).
3.
Install instrument panel (6) on cowl (9) with screw (8).
4.
Install instrument panel (6) and hand throttle bracket (21) on steering column bracket (12) with
capscrew (10), washer (11), nut (13), and washer (11).
5.
Install hand throttle bracket (21) to instrument panel (6) with screw (23) and nut (22).
6.
Install instrument panel (6) to body (19) with two capscrews (17), washers (18), nuts (20), and
washers (18).
7.
Install cannon plug (16) on main light switch (15).
8.
Raise steering column (7) and tighten nut (14) to 31 lb-ft (42 Nm).
