TM 1-4940-355-12&P
0020 00
4. Bolt front of main box in place with two bolts (1), two lock washers (2), two flat washers (3), and two spacers
(4). (Figure 3) Reuse hex nuts from tie-down rings stored with the Organizational Maintenance during
VEHICLE PREPARATION.
MS019476
Figure 3. Front Attachment (Typical Two Places)
NOTE
If permanently attached threaded nut plates have been installed, they must be
removed from HMMWV at the three rear most locations in order to install Main
Box.
5. Bolt rear of main box in place with three 3/8-16 x 2 inch bolts (1), lock washers (2) and flat washers (3). Bolt
locations are underneath vehicle. (Figure 4)
Figure 4. Rear Attachment (Typical Three Places)
Change 1