TM 9-2330-392-14&P
4-34.
RADIAL TIRE, WHEEL, AND RUNFLAT REPAIR (Con’t).
17. Remove two lubricant packets (23) and adhesive tape (22) from runflat (13).
b.
INSPECTION AND CLEANING
CAUTION
Do not reuse a tire that has been run flat without thoroughly inspecting for damage. Failure to follow these
instructions may result in damage to equipment.
1.
Inspect inside of tire (6) for cord or belt separation and inner liner damage. Replace tire (6) if damaged.
2.
Inspect tire bead (20) for abrasions caused from runflat (13). Replace tire (6) if damaged.
3.
Check for protruding objects inside tire (6) that may not be visible from outside. Repair tire (6) if damaged.
4.
Check tread depth on tire (6). Tread should not be worn below level of wear bars (21). Replace tire (6) if tread is
worn below wear bars (21) or 3/32 in. (2.38 mm).
5.
Inspect runflat spacer (7) for splitting, wear, or excessive chafing Replace runflat spacer (7) ifdamaged.
6.
Inspect runflat (13) for splitting, wear, or excessive chafing. Replace runflat (13) if damaged.
4-89
