TM 9-2330-392-14&P
Change 2
4-47
4-24.
SERVICE BRAKESHOE REPLACEMENT (Con’t).
5.
Install travel link (21) to backing shoe lever (15) with capscrew (22) and locknut (23). Measure clearance
between backing shoe lever (15) and travel link (21). Tighten locknut (23) and capscrew (22) to ensure 0.03-inch
clearance.
WARNING
DO NOT allow grease to contact brakeshoe linings. Wipe excess lubricant from the brakeshoe lin-
ings to prevent grease soaking into the materials. Brakeshoe linings can absorb grease and oil, caus-
ing early glazing of linings and very poor breaking action. If brakeshoe linings become soaked,
notify Direct Support (DS) maintenance shop for replacement. Failure to follow this warning may
cause brakes to malfunction, resulting in injury or death to personnel or damage to equipment.
6.
Install capscrew (26) and locknut (27) securing backing shoe lever (15) to front brakeshoe (4). Tighten locknut
(27) and capscrew (26) to ensure 0.03-inch clearance between backing shoe lever (15) and front brakeshoe (4).
7.
Install pin (24) and retaining ring (28) securing parking shoe lever (25) to front brakeshoe (4) and backing shoe
lever (15).
8.
Install spring (29) to front brakeshoe (4) and pin (24).
9.
Install washer (30), transporter washer (20), new lockwasher (19), and spring tension clip (18) securing parking
brake link (6) to rear brakeshoe (2).
