TM 9-2330-392-14&P
4-46
Change 2
4-24
SERVICE BRAKESHOE REPLACEMENT (Cont).
c.
ASSEMBLY
NOTE
Steps 1 through 4 are required only if backing plate was removed.
1.
Install backing plate (9) on axle spindle (37) and secure with mounting studs (36) and nuts (35). Tighten nuts and
torque to 50 ± 5 ft-lb (69 ± 7 N m).
2.
Remove plug from flex brake line (33), then connect flex brake line (33) to wheel cylinder (38).
3.
Install wheel cylinder (38) on backing plate (9) with new capscrews (34). Torque capscrews to 168 ± 17 in-lb (19
± 1.9 N m).
4.
Feed handbrake cable (5) through backing plate (9), then connect cable sheath (32) to backing plate (9).