TM 9-2320-387-24-2
1 1 O-28. WINDSHIELD
ASSEMBLY MAINTENANCE
(Ml 113)
This task covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
INITIAL SETUP:
Applicable Models
Ml113
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
l Soft top enclosure removed, if installed
(TM 9-2320-387-10).
l Windshield wiper arm pivot removed (para. 10-60).
l Windshield retention bracket removed (para. 10-29).
General Safety Instructions
Windshield must be supported during removal and
installation.
hlaintenance Level
Unit
WARNING
Windshield must be supported during removal and installation.
Failure to
support windshield may cause injury to personnel or damage to equipment.
r-zzz-1
1.
Remove five hitch pins (5) from hinge pins (6).
2.
Remove five hinge pins (6) from upper hinge halves (2) and lower hinge halves (41.
3.
Remove grommet (11) from A-pillar (12) and remove jumper harness (10).
4.
Remove windshield
assembly (1) from A-pillar (12).
5.
Remove two seals (3) from windshield assembly (1).
6.
Clean remains of seal (3) from windshield assembly (1).
b. Disassembly
1.
Remove thirteen screws (91, former (81, and seal (7) from windshield assembly (1).
2.
Clean remains of seal (7) from windshield assembly (1).
I]
1.
Peel paper backing from seal (7) and install seal (7) on windshield assembly (1).
2.
Install former (8) on seal (7) and windshield assembly (1) with thirteen screws (9).
-1
1.
Peel paper backing from two seals (3) and install seals (3) on windshield assembly (1).
2.
Install windshield
assembly (1) on A-pillar (12).
3.
Install jumper harness (10) on windshield center pillar (13) and install grommet (11) on A-pillar (12).
4.
Install upper hinge halves (2) on lower hinge halves (4) with five hinge pins (6).
5.
Install five hitch pins (5) in hinge pins (6).
1 o-52
