TM 9-2320-387-24-2
10-56
Change 1
10-31. LEFT FRONT COWL INSULATION REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Five locknuts (Appendix G, Item 109)
Two lockwashers (Appendix G, Item 205)
Sealing compound (Appendix C, Item 72.1)
Manual References
TM 9-2320-387-24P
Personnel Required
One mechanic
One assistant
Equipment Condition
Headlight beam selector switch and bracket
removed (para. 4-59).
Maintenance Level
Unit
NOTE
M1114 models are equipped with insertnuts, not with nuts and
lockwashers as indicated in step 1.
1.
Remove two nuts (1), capscrews (5), lockwashers (4), and clamps (3) from wiring harness (2),
insulation (10), and body (6). Discard lockwashers (4).
NOTE
Perform steps 2 and 3 for M1113 vehicles only.
2.
Remove locknut (17), washer (16), spacer (15), capscrew (8), and washer (7) from insulation (10) and
floor (12). Discard locknut (17).
3.
Remove four locknuts (13), washers (14), capscrews (9), retainer (11), and insulation (10) from
floor (12). Discard locknuts (13).
NOTE
Perform steps 1 and 2 for M1113 vehicles only.
1.
Install insulation (10) and retainer (11) on floor (12) with four capscrews (9), washers (14), and
locknuts (13). Tighten locknuts (13) to 6 lb-ft (8 N•m).
2.
Install washer (7), capscrew (8), spacer (15), washer (16), and locknut (17) on insulation (10) and
floor (12).
NOTE
M1114 vehicles are equipped with insertnuts, not with nuts and
lockwashers as indicated in step 3. Apply sealing compound to
threads of capscrews at installation for M1114 vehicles only.
3.
Install wiring harness (2) on insulation (10) and body (6) with two clamps (3), lockwashers (4),
capscrews (5), and nuts (1).
b. Installation
a. Removal
