TM 9-2320-387-24-2
16-8. FUEL INJECTION PUMP SHUTOFF SOLENOID MAINTENANCE
This task covers:
a. Removal
b. Inspection
c. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Three lockwashers (Appendix G, Item 1981
Locknut (Appendix G, Item 1601
Two fiber washers (Appendix G, Item 501
Manual References
TM 9-2320-387-24P
Equipment Condition
Fuel injection pump cover removed (para. 16-71.
Maintenance Level
Direct support
NOTE
Working area should be clean, well-ventilated, and free from
blowing dirt and dust.
rxzzl
1.
Remove terminal (51, washer (61, and shell (7) from stud (12).
2.
Remove nut (81, lockwasher (91, washer (lo), and fiber washer (11) from stud (12). Discard
lockwasher (9) and fiber washer (111.
3.
Remove locknut (41, ground strap (3), lockwasher (21, nut (81, lockwasher (91, washer (lo), and fiber
washer (11) from stud (14). Discard locknut (4), lockwashers (2) and (9), and fiber washer (11).
4.
Remove electrical shutoff solenoid (13) from cover (11.
I[
Inspect shell (7). Replace if cracked, deteriorated, or damaged.
c. Installation
1.
Install electrical shutoff solenoid (13) in cover (1).
2.
Install fiber washer (111, washer (101, lockwasher (91, nut (81, lockwasher (2), ground strap (31, and
locknut (4) on stud (14).
3.
Install fiber washer (111, washer (lo), lockwasher (91, and nut (81 on stud (12).
4.
Install shell (71, washer (61, and terminal (5) on stud (121.
16-16
