TM 9-2320-387-24-2
16-9. FUEL INJECTION PUMP COLD-ADVANCE SOLENOID MAINTENANCE
This task covers:
a. Removal
b. Inspection
c. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two lockwashers (Appendix G, Item 198)
Manual References
TM 9-2320-387-24P
Equipment Condition
Fuel injection pump shutoff solenoid removed
(para. 16-8).
Locknut (Appendix G, Item 160)
O-ring (Appendix G, Item 256)
Two fiber washers (Appendix G, Item 50)
Maintenance Level
Direct support
NOTE
Working area should be clean, well-ventilated, and free from
blowing dirt and dust.
IYzz-/
1.
Remove terminal (l), washer (2), and ribbed shell (3) from stud (15).
2.
Remove nut (4), lockwasher (5), washer (6), and fiber washer (7) from stud (15). Discard lock-
washer (5) and fiber washer (7).
3.
Remove locknut (II), nut (4), lockwasher (5), washer (6), and fiber washer (7) from stud (12). Discard
lockwasher (5), locknut (ll), and fiber washer (7).
4.
Remove check valve (9) and O-ring (8) from cover (10). Discard O-ring (8).
5.
Remove cold-advance solenoid (13) and plunger (14) from cover (10).
6.
Remove plunger (14) from cold-advance solenoid (13).
b. Inspection
Inspect ribbed shell (3). Replace if cracked, deteriorated, or damaged.
(1
I.
Install plunger (14) in cold-start advance solenoid (13). Install stud (15) in hole in rear of cover (10).
2.
Install O-ring (8) and check valve (9) in cover (10).
3.
Install cold-start advance solenoid (13) in cover (10) so small tip of plunger (14) fits in port of check
valve (9) and stud (12) fits through hole in side of cover (10).
4.
Install fiber washer (7), washer (6), lockwasher (5), nut (4), and locknut (11) on stud (12).
5.
Install fiber washer (7), washer (6), lockwasher (5), and nut (4) on stud (15).
6.
Install ribbed shell (3), washer (2), and terminal (1) on stud (15).
16-18
