TM 9-2320-387-24-2
1528.
ENGINE INSTALLATION (Cont’d)
88.
Align radiator assembly (3) and oil cooler (33) to frame bracket (38) and two rear support brackets (13)
to airlift brackets (7).
89.
90.
91.
92.
93.
Install two rear support brackets (13) on airlift brackets (7) with four capscrews (121, washers (111,
and locknuts (10). Do not tighten locknuts (10).
Install radiator assembly (3), large washer (361, and mount (37) on frame bracket (38) with large
washer (36), washer (391, capscrew (40), washer (351, and locknut (34). Do not tighten capscrew (40).
Install crossbrace (23) on airlift brackets (7) with four capscrews (201, washers (211, and
locknuts (22).
94.
95.
Tighten nut (24) to increase tension on crossbrace (23).
Connect two transmission oil cooler line connector hoses (32) to transmission oil cooler ports (30) and
tighten hose clamps (31) to lo-20 lb-in. (l-2 Nom).
Connect two engine oil cooler supply and return lines (27) to engine oil cooler ports (28).
Connect two power steering hoses (25) to power steering cooler ports (29) and tighten clamps (26).
NOTE
l Fan shroud should be aligned so the following dimensions are
maintained. Adjustments may be made by tilting the
radiator/shroud assembly. Distance A from the edge of shroud
ring and rear edge of fan must be l-If2 f 1/4 in. (38.12 6 mm).
Measure distance A at the 2,4, 8, and 10 o’clock positions.
l Fan blade to fan shroud clearance, the distance between the top
of the fan blade and fan shroud, must not be less than l/4 in.
(6 mm) at any position.
96.
Align radiator assembly (3) and tighten locknuts (10) to 26 lb-ft (35 Nom). Tighten capscrew (40) to
30 lb-ft (41 N-m).
97.
Connect lower radiator front hose (9) to radiator (3) and tighten clamp (8).
98.
Connect fan drive hose quick-disconnect (15) to fan drive disconnect (16).
99.
Connect control valve hose (18) to bulkhead adapter (17) and tighten clamp (19).
100.
Connect radiator inlet hose (2) to engine (14) and tighten clamp (1).
101.
Connect surge tank-to-radiator vent hose (4) to adapter (6) and tighten clamp (5).
2 O’CLOCK POSmoN
10 O’CLOCK POSITION
4 O’CLOCK POWION
8 O’CLOCK POSITION
15-118
