TM 9-2320-387-24-2
15-28. ENGINE INSTALLATION (Cont’d)
115.
116.
117.
118.
119.
120.
121.
Install right splash shield (1) on airlift bracket (5) with washer (4) and screw (3).
Install right splash shield (1) on support bracket (16) with washer (17), capscrew (18), washer (71,
and locknut (8). Tighten capscrew (18) to 15 lb-ft (20 N-m).
NOTE
Perform steps 117 and 118 for Ml113 models only.
Install right splash shield (1) on airlift bracket (5) with two washers (201, capscrews (191, clamp (211,
washer (241, washer (22), and locknut (23). Tighten capscrews (19) to 15 lb-R (20 N-m).
Install vent line clamp (27) on right splash shield (11 with capscrew (21, washer (251, and locknut (26).
Tighten locknut (26) to 15 lb-R (20 N-m).
Install harness connector (29) on plate (12) with four screws (28) and nuts (30).
Install plate (121 and spring nuts (11) on headlight housing (9) with two hex-head screws (10).
Install right splash shield (1) on bracket (6) and plate (12) with four lockwashers (141, washers (13),
and capscrews (15).
