12-39. AIR CLEANER SHIELD MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Inspection
a. Removal
1.
Loosen clamp (3) and disconnect air horn-to-air cleaner elbow (4) from air cleaner assembly (6).
2.
Disconnect air cleaner-to-selector valve vent line (2) from air cleaner assembly (6).
3.
Disconnect air restriction gauge hose (5) from air cleaner assembly (6).
4.
Loosen two clamps (7) from air cleaner assembly (6) and support brackets (9).
4.1. Remove three screws (1.2), washers (1.3), and air cleaner shield (1.1) from
air induction box (1).
5.
Remove air cleaner assembly (6) and gasket (8) from air induction box (1).
INITIAL SETUP:
Applicable Models
M1113
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Manual References
TM 9-2320-387-24P
Equipment Condition
Air intake assembly removed (para. 3-19).
Maintenance Level
Unit
TM 9-2320-387-24-2
12-72
Change 1
b. Inspection
Inspect gasket (8). Replace if broken or cracked.
c. Installation
1.
Install air cleaner assembly (6) and gasket (8) on air induction box (1) and support brackets (9)
with two clamps (7). Tighten clamps (7) to 35-40 lb-in. (4-5 N•m).
2.
Install air cleaner shield (1.1) on air induction box (1) with three washers (1.3) and screws (1.2).
3.
Connect air restriction gauge hose (5) to air cleaner assembly (6).
4.
Connect air cleaner-to-selector valve vent line (2) to air cleaner assembly (6).
5.
Connect air horn-to-air cleaner elbow (4) to air cleaner assembly (6). Tighten clamp (3) to
45-50 lb-in. (5-6 N•m).
