TM 9-2320-387-24-2
I 12-38. DEEP WATER FORDING KIT EXHAUST ASSEMBLY MAINTENANCE
1
This task covers:
a. Removal
b. Inspection
c. Installation
INITIAL SETUP:
Applicable Models
Ml113
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Gasket (Appendix G, Item 55)
Five locknuts (Appendix G, Item 124)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
General Safety Instructions
Do not touch hot exhaust system components with
bare hands.
nlaintenance
Level
Unit
WARNING
Do not touch hot exhaust system components with bare hands.
Severe injury will result.
a. Removal
1.
Remove two nuts (141, washers (131, and U-bolt (12) from exhaust assembly (9).
2.
Remove two locknuts (4), washers (51, and two spacers (8) from wheelhouse (7) and exhaust
assembly (9). Discard locknuts (4).
3.
Remove three locknuts (11, washers (21, capscrews (101, washers (21, exhaust assembly (91, and
gasket (11) from muffler (3). Discard locknuts (1) and gasket (11).
b. Inspection
Inspect two insulators (6) for breaks, cracks, or deterioration. Replace if damaged.
I c. Installation -1
1.
Install two spacers (8) and exhaust assembly (9) on wheelhouse (7) with two washers (5) and
locknuts (4). Tighten locknuts (4) to 37 lb-ft (50 Nom).
2.
Install exhaust assembly (9) and gasket (11) on muffler (3) with three washers (21, capscrews (lo),
washers (21, and locknuts (1). Tighten locknuts (1) to 26 lb-ft (35 N-m).
3.
Install U-bolt (12) on exhaust assembly (9) with two washers (13) and nuts (14).
12-70
