TM 9-2320-387-24-2
12-68.26
Change 1
12-36.6. 10,500 LB REAR HYDRAULIC WINCH CONTROLLER PLUG REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Three tiedown straps (Appendix G, Item 463)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Battery ground cables disconnected
(para. 4-68).
Maintenance Level
Unit
1.
Remove three tiedown straps (2) from lead wire (4), controller plug harness (3), valve assembly
wires (5), and body wiring harness (1). Discard tiedown straps (2).
2.
Disconnect controller plug lead 785C (14) from valve assembly lead 785C (13).
3.
Disconnect controller plug lead 785B (10) from circuit breaker (15).
4.
Disconnect controller plug lead 785A (11) from valve assembly lead 785A (12).
5.
Remove four screws (7) and controller plug (6) with cap and chain (8) from body panel (9).
6.
Remove controller plug harness (3) from around fuel filter (17) and back through hole in body
panel (16).
a. Removal
