TM 9-2320-387-24-2
I
1 l-62.
TURRET PINTLE MOU.NT MAINTENANCE
This task covers:
a. Removal
b. Inspection
c. Installation
INITIAL SETUP:
Applicable Models
Ml114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
RTV sealant (Appendix C, Item 74)
Sealing compound (Appendix C, Item 64)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Turret hatch open (TM 9-2320-387-10X
Maintenance Level
Unit
1. Remove twelve capscrews (6) and washers (7) from turret armor (3) and turret pintle mount (1).
2. Remove capscrew (5) and washer (4) from turret armor (3) and turret pintle mount (1).
3. Remove turret pintle mount (1) from turret armor (3).
4. Remove four screws (9), pin assembly (81, and pintle brush seal (2) from turret pintle mount (1).
b. Inspection
Inspect pintle brush seal (2). Replace if damaged.
vf.Installationl
1.. Install pintle brush seal (2) and pin assembly (8) on turret pintle mount (1) with four screws (9).
Tighten screws (9) to 30 lb-in. (3 N-m).
2. Apply sealant to thirteen bosses (10) on bottom of pintle mount (1) and around holes in turret armor (3).
3. Install turret pintle mount (1) on turret armor (3) with washer (4) and capscrew (5). Do not tighten
capscrew (5).
NOTE
Apply sealing compound to capscrews prior to installation.
4. Install twelve washers (7) and capscrews (6) on turret pintle mount (1) and turret armor (3). Tighten
capscrews (6) and (5) to 37 lb-R (50 Nom).
1 l-120
