TM 9-2320-387-24-2
1 l-61. TURRET HATCH ASSEMBLY COMPONENTS REPLACEMENT (Cont’d)
NOTE
Apply a small amount of sealant around all screw holes prior to
installation of components.
f. Protective Bumper Installation
1.
Install protective bumper (2) on turret hatch (4) with two screws (1) and nuts (3). Tighten nuts (3) to
10 lb-R (14 N=m).
2.
Lower and close turret hatch (4).
g. Hatch Support Rod Clip Installation
1.
Install hatch support rod clip (5) on turret hatch (4) with two screws (6) and locknuts (15). Tighten
locknuts (15) to 30 lb-in. (3 Nom).
2.
Lower and close turret hatch (4).
h. Strap Fastener Loop Installation
1.
Install lifting loop (18) and strap fastener loop (17) on turret hatch (4) with two screws (16) and
locknuts (19). Tighten locknuts (19) to 30 lb-in. (3 Nom).
2.
Lower and close turret hatch (4).
i. Pivot Lug Installation
NOTE
Pivot lug must rotate by hand after installation.
1.
Lightly lubricate shaft of pivot lug (10) and O-ring (12) and install pivot lug (10) on turret hatch (4)
with washer (111, O-ring (121, washer (131, and nut (14). Ensure pivot lug (10) will rotate by hand.
2.
Install pivot rod (81 (task j.).
j. Pivot Rod Installation
1.
Install pivot rod (8) on pivot lug (10) with socket-head screw (9) and locknut (7). Tighten locknut (7)
to 21 lb-R (28 Nom).
2.
Connect pivot rod (8) to hatch support rod clip (5).
3.
Lower and close turret hatch (41.
ii-ii8
