11-41.2. PASSENGER SIDE FOOTWELL INNER ARMOR REPLACEMENT
This task covers:
a. Removal
c.
Installation
b. Inspection
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Eleven locknuts (Appendix G, Item 171)
Sealing compound (Appendix C, Item 72.1)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-24P
Equipment Condition
• Rifle support removed (para. 11-66).
• Engine access cover removed (para. 10-22).
• A/C front distribution duct removed (para. 11-81).
• A/C heater/evaporator assembly removed
(para. 25-21).
• Tunnel interior side insulation removed
(para. 10-33).
• Right front cowl insulation removed (para. 10-32).
• Surge tank removed (para. 3-65).
• Right front underbody armor removed (para. 11-38).
Maintenance Level
Unit
TM 9-2320-387-24-2
11-84.4
Change 1
NOTE
If new passenger side footwell inner armor is being installed,
perform para.11-38.1.
NOTE
Note location of capscrews and locknuts for installation.
1.
Remove screw (6) and circuit breaker (5) from footwell armor (3).
2.
Remove eight capscrews (4) from body (7) and footwell armor (3).
3.
Remove eleven locknuts (1), capscrews (8), inner/outer cowl reinforcement (2), and footwell armor (3)
from body (7). Discard locknuts (1).
Refer to para. 10-56 for plusnut inspection and replacement.
1.
Apply sealing compound to threads of eight capscrews (4) and install capscrews (4) on footwell
armor (3) and body (7). Tighten capscrews (4) to 37 lb-ft (50 N•m).
2.
Install footwell armor (3) and inner/outer cowl reinforcement (2) on body (7) with eleven
capscrews (8) and locknuts (1). Tighten locknuts (1) to 37 lb-ft (50 N•m).
3.
Install circuit breaker (5) on footwell armor (3) with screw (6).
c. Installation
b. Inspection
a. Removal
