WARNING
Drycleaning solvent is highly flammable. Do not perform this pro-
cedure near fire, flames, or sparks. Injury to personnel and/or
damage to equipment will result.
NOTE
Use drycleaning solvent to remove adhesive from window chan-
nels.
1.
Remove three seals (2) from window channels (3).
2.
Remove five seals (1) from window channels (3).
1.
Apply a thin coat of adhesive on inside of window channel (3).
NOTE
Seal is supplied in bulk and must be cut to fit.
2.
Trim three seals (2) to fit window channels (3), as required.
NOTE
Ensure mating surfaces of seals are installed on window channels
evenly.
3.
Apply a thin coat of adhesive on three seals (2) and install seals (2) on window channels (3).
NOTE
Two seals will be trimmed 21.25-in. (540 mm) in length, two seals
will be 20.00-in. (508 mm) in length, and one seal will be 16.00-in.
(406 mm) in length.
4.
Trim five seals (1) to fit window channels (3), as required.
NOTE
Ensure mating surfaces of seals are installed on window channels
evenly.
5.
Apply a thin coat of adhesive on edges of window channels (3) and on contact edge of five door
seals (1).
NOTE
Two seals are located on right side, two seals on left side, and one
seal on top of window channels.
6.
Install five seals (1) on window channels (3).
b. Installation
a. Removal
11-10. DOOR WINDOW SEAL REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Seal (Appendix G, Item 377)
Drycleaning solvent (Appendix C, Item 26)
Adhesive (Appendix C, Item 4)
Manual References
TM 9-2320-387-24P
Equipment Condition
Door window removed (para. 11-3).
General Safety Instructions
Do not perform this procedure near fire, flames, or
sparks.
Maintenance Level
Unit
TM 9-2320-387-24-2
11-20
Change 1
