TM 9-2320-387-24-2
1 O-81. DIVERTER BOX MAINTENANCE
This task covers:
a. Removal
b. Disassembly
INITIAL SETUP:
c. Assembly
d. Installation
Applicable
Models
Ml113
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Pushnut
(Appendix G, Item 313)
Two rivets (Appendix G, Item 342)
Four rivets (Appendix G, Item 335)
Equipment
Conditions
Diverter
ducting removed (para. 10-86).
Manual References
TM 9-2320-387-24P
Maintenance
Level
Unit
a. Removal
1.
Remove two screws (14) from transition diverter (12) and transition (13).
2.
Remove two screws (8) from diverter (9) and heater (7).
3.
Remove screw (5) and clamp (4) from diverter (9).
4.
Remove pushnut (11) and disconnect defroster cable core (6) from baffle pin (10). Discard pushnut Gl).
5.
Pull diverter (9) away from A-beam (l), loosen two clamps (3), and remove diverter (9) from flex
ducts (2).
b; Disassembly
1.
Remove four rivets (21) and transition diverter (12) from diverter (9).
2.
Remove screw (E), spring (16), and louver (17) from transition diverter (12).
3.
Remove two rivets (19), flap (20), and bracket (18) from diverter (9).
rTzzq
1.
Install flap (20) and bracket (18) on diverter (9) with two rivets (19).
2.
Install louver (17) on transition diverter (12) with spring (16) and screw (15).
3.
Install diverter (9) on transition diverter (12) with four rivets (21).
1
d. Installation
1
1.
Position diverter (9) under A-beam (1) and connect two defroster flex ducts (2) on diverter (9).
2.
Secure flex ducts (2) to diverter (9) with two clamps (3).
3.
Connect defroster cable core (6) on baffle pin (10) and secure with pushnut (11).
4.
Install transition diverter (12) on transition (13) with two screws (14).
NOTE
Control cable must be pushed in, and baffle pin must be in the
upward position before securing control cable to diverter box.
. .
5.
Install clamp (4) on diverter (9) with screw (5).
6.
Install diverter (9) on heater (7) with two screws (8).
10-140
