10-64. WINDSHIELD WASHER RESERVOIR AND PUMP ASSEMBLY MAINTENANCE
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Battery ground cables disconnected (para. 4-68).
Hood raised and secured (TM 9-2320-387-10).
Maintenance Level
Unit
This task covers:
a.
Removal
b. Installation
a.1. Inspection
a. Removal
NOTE
M1114 models are equipped with plusnuts, not with nuts,
washers, and lockwashers as indicated in steps 1 and 2.
1.
Remove two nuts (17), lockwashers (18), capscrews (1), and washers (2) from reservoir (3),
pump (8), and cowl (19). Discard lockwashers (18).
2.
Remove nut (14), lockwasher (15), washer (16), capscrew (4), and washer (5) from pump (8) and
cowl (19). Discard lockwasher (15).
3.
Disconnect hose (6) from pump (8).
4.
Disconnect harness lead 57D (12) and lead 71C (13) from pump terminals (11) and remove
grommet (7) and reservoir (3) from cowl (19).
5.
Remove pushnut (10), seal (9), and pump (8) from reservoir (3).
TM 9-2320-387-24-2
10-108
Change 1
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Three lockwashers (Appendix G, Item 207)
Seal (Appendix G, Item 428)
a.1. Inspection
For plusnut inspection and replacement (M1114), refer to para 10-56.
b. Installation
1.
Install seal (9) and pump (8) on reservoir (3) with pushnut (10).
2.
Position reservoir (3) on cowl (19), connect harness lead 57D (12) and lead 71C (13) to pump
terminals (11), and install grommet (7) on cowl (19).
3.
Connect hose (6) on pump (8).
NOTE
M1114 models are equipped with plusnuts, not with nuts, washers,
and lockwashers as indicated in steps 4 and 5.
4.
Install pump (8) on cowl (19) with washer (5), capscrew (4), washer (16), lockwasher (15), and
nut (14). Tighten nut (14) to 6-10 lb-ft (8-14 Nm) on M1113 and capscrew (4) to 36 lb-in. (4 Nm)
on M1114.
5.
Install reservoir (3) and pump (8) on cowl (19) with two washers (2), capscrews (1), lockwashers (18),
and nuts (17). Tighten nuts (17) to 8 lb-ft (11 Nm) on M1113 and capscrew (1) to 68-82 lb-in.
(8 Nm) on M1114.
