TM 9-2320-387-24-2
Change 1
10-103
1.
Remove two access covers (7) (M1113), or eight capscrews (8), lockwashers (8.1), washers (8.2), and
two plates (9) (M1114), from windshield frame (1). Discard lockwashers (8.1).
2.
Pull connector arm retainer (3) from ball stud (5) and remove motor drive lever (6) from connector
arm (4).
3.
Disconnect connector arm (4) from wiper arm pivots (2) and remove connector arm (4) through
center access in windshield frame (1).
CAUTION
Install left (driver’s) side connector arm first, or damage to
equipment will result.
1.
Install connector arm (4) through center access on windshield frame (1) and connect connector
arm (4) to wiper arm pivots (2).
2.
Connect connector arm (4) together with motor drive lever (6) and connector arm retainer (3) on ball
stud (5).
3.
Install two access covers (7) (M1113), or two plates (9) with eight washers (8.2), lockwashers (8.1),
and capscrews (8) (M1114), on windshield frame (1). Tighten capscrews (8) to 75 lb-in. (9 N•m).
b. Installation
a. Removal
10-61. WINDSHIELD WIPER LINKAGE REPLACEMENT
This task covers:
a. Removal
b. Installation
Manual References
TM 9-2320-387-24P
Equipment Condition
Windshield wiper motor removed (para. 10-63).
Maintenance Level
Unit
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Eight lockwashers (Appendix G, Item 207)
FOLLOW-ON TASK: Install windshield wiper motor (para. 10-63).
9
M1114
3
5
6
4
7
2
8.1
1
8.2
8
