34-3. SUSPENSION ALIGNMENT INSTRUCTIONS
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Alignment equipment, vehicle (Appendix B,
Item 113.1)
Materials/Parts
Two locknuts (Appendix G, Item 174)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Tires inflated to proper pressure
(TM 9-2320-387-10).
Maintenance Level
General support
This task covers:
a. Caster and Camber Check
c. Toe Check and Adjustment
b. Caster and Camber Adjustment
NOTE
• The alignment check will be made on a level surface, with front
tires in the straight-ahead position. Vehicles will be checked at
curb weight only.
• Ensure M1113 models have S250 shelter installed before
performing caster and camber checks.
• Ensure M1114 models are at curb weight when performing
caster and camber checks.
1.
Check caster and compare to the specifications in table 34-1.
2.
Check camber and compare to the specifications in table 34-1.
3.
If either caster or camber does not meet specifications, go to task b, caster and camber adjustment.
a. Caster and Camber Check
TM 9-2320-387-24-2
Change 1
34-1
CHAPTER 34
SUSPENSION (GS) MAINTENANCE
34-2. SUSPENSION MAINTENANCE TASK SUMMARY
TASK
PAGE
PARA.
PROCEDURES
NO.
34-3.
Suspension Alignment Instructions
34-1
34-1. INTRODUCTION
This chapter contains maintenance instructions for suspension system components at the general support
maintenance level. Some subassemblies and parts must be removed before suspension system components
can be accessed. They are referenced to other paragraphs of this manual.
