33-13. RIGHT FRONT FLOOR PANEL REPAIR (Cont’d)
TM 9-2320-387-24-2
33-70
Change 1
1.
Cut metal strip (1) from sheet metal, and mark two reference lines (2), centerline (3), and
directional arrow (4). Identify metal strip (1) as A.
2.
Locate, mark, and drill twenty-four 0.187-in. (4.75-mm) diameter holes through metal strip A (1).
3.
Cut metal strip (5) from sheet metal, and mark two centerlines (6), and directional arrow (7).
Identify metal strip (5) as B.
4.
Locate, mark, and drill twenty 0.187-in. (4.75-mm) diameter holes in metal strip B (5).
5.
Cut metal strip (8) from sheet metal, and mark two centerlines (9) and directional arrow (10).
Identify metal strip (8) as C.
6.
Locate, mark, and drill eighteen 0.187-in. (4.75-mm) diameter holes through metal strip C (8).
b. Metal Strips Fabrication
METRIC CONVERSION
0.60 IN.
15.24 MM
0.75 IN.
19.05 MM
1.25 IN.
31.75 MM
1.40 IN.
35.56 MM
1.50 IN.
38.10 MM.
METRIC CONVERSION
2.00 IN.
50.80 MM
2.50 IN.
63.50 MM
3.00 IN.
76.20 MM
13.75 IN.
349.25 MM
32.50 IN.
825.50 MM
DRILL TWENTY-FOUR 0.187-IN. (4.75-MM)
DIAMETER HOLES
